Typically, I will AMA link to footage inside the P2 folders on an
attached hard drive, name and sort the clips, and then transcode the
clips first to a DNx resolution, then to SD 20:1 resolution for offline
multicam editing. When the cut is locked, I simply relink to the DNx and
all is well.
Sometimes, there is so much raw footage, or the edited piece so short,
that I will edit with the AMA clips, then transcode the sequence to a
DNx res. In a particular sequence, I did this, and the DNx clips were
accidentally deleted. Is there a way to relink the offline subclips to
the online AMA master clips?
I believe what I should do in the future is to first consolidate the
sequence made from the AMA clips, then transcode the consolidated AMA
media. That way, if the transcoded media goes offline, I will have AMA
clips that will relink.
Thanks for advice and workflow suggestions.
frank felker
--
Posted by: Frank Felker <fjfelker@gmail.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (1) |
No comments:
Post a Comment