Hi all,
I'm having a problem with a classic Symphony Nitris system. It's the usual xw8400, Nitris BOB, Avid Mediadock local SCSI storage, with version 5.03 of Symphony.
Although everything seemed to startup fine (no hardware errors, BOB power switch shows green and I can see video output from BOB), there's a problem occurring when you try to add any effect to a sequence. When you do, the system becomes extremely sluggish, the clip refuses to play and the error 'SFPlayConsumer::Execute TIMEOUT' appears on the record monitor. If you wait around ten seconds and remove the effect then it behaves normally. This seems to happen with any effect or when you apply a colour correction. Tried new project and restarting PC and BOB with no success. Tried Googling and there was some mention of Wacom drivers, but I don't have any Wacom device installed. There was also a mention that it might be corrupt media or bad stripe, so I captured some new media on the C drive (to rule out the SCSI devices), put it into a new sequence but without success.
Anyone come across this one before?
Thanks
Bruno
No comments:
Post a Comment