The drivers for the new computer hardware (i.e: new video card) won't be in the older OS version. You will have to add these drivers manually to the older OS.
Ofer Raveh
ACSR Elite, DS
On Tuesday, December 29, 2015 10:42 AM, "Dennis Degan DennyD1@verizon.net [Avid-L2]" <Avid-L2@yahoogroups.com> wrote:
I take a deep breath and say:
I'm going to say this one more time and I hope it gets absorbed: IT is NOT recommended by Apple to install a version of operating system that predates the version that the computer came with. HOWEVER, if you are willing to take the risk and do it anyway, I do recall that it is possible to do so by taking the drive out of the computer, install the older OS on it using another (newer) computer, put it back into the first computer and hope for the best. You might even be able to install an earlier version by running the computer in Target Mode to install that earlier OS version. There are 3 possibilities as to what will happen next: (1) The computer won't work; won't start up at all or won't get past a certain startup point. (2) The computer won't start up and you may actually damage something . . . . possibly permanently. (3) The computer will start up, appear to work fine, but may exhibit instabilities or crashes in the future that are seemingly unpredictable and may cost you time and money.
Given the above analysis, I simply say 'DO NOT DO THIS'. It is not worth the risk. You have been warned . . . . repeatedly.
BTW, the below instructions most likely were to allow the user to revert to an earlier OS version that WAS SUPPORTED by the computer in question. If there are Time Machine backups from a particular computer, that means the earlier version OS ran on that computer and was supported by it. I have not read anything coming from Apple that suggests you can install any version of the OS on a Mac that precedes the version which came with the computer.
DDD
On Dec 29, 2015, at 12:41 PM, bigfish@pacbell.net wrote:
Here's something from Apple regarding a time machine backup approach. I have bootable flash drives of 10.7, 10.8, 10.9 and 10.10. Could I boot to one of them on a new MBP and do a clean install on the internal flash drive or are there those hardware or software blocking mechanisms in place that will not allow that to happen. I know that's been the case in the past on various hardware firmware for macs. From Apple:OS X Yosemite: Revert to a previous OS X version
Important: Reverting erases any changes you made to the files on your Mac since you installed the new version of OS X. To save new or revised files, copy them onto a different disk or back them up before you follow these instructions.
---In avid-l2@yahoogroups.com, <bigfish@...> wrote :I recall a fairly recent thread regarding how to back rev the OS on a MBP but IIRC the suggestion was about taking the hard drive to an external enclosure and and installing an older OS that way. I've done that in the past on Mac Pros. I purchased an MBP 13 inch over Xmas and learned that it works off an internal flash drive that is soldered to the motherboard. Having learned this I'm curious how one can install a previous OS on the internal flash drive. Is this something that would be done launching the MBP in target mode. Is it even possible?John Moore Barking Trout Productions Studio City, CA bigfish@...
__._,_.___
Posted by: Ofer Raveh <o.raveh@att.net>
Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (4) |
this is the Avid-L2
.
__,_._,___
No comments:
Post a Comment