We know its been a long wait, but Yosemite support for EuControl and Workstation is now available in v3.2.2!
Thanks for your patience while we got this release tested and out to the general public.
Please pay special attention to the note about updating the firmware on each of your surfaces. This is required for proper connectivity with Yosemite, but the update process can be a little tricky. This is because with older firmware, surfaces do not consistently attach in EuControl on Yosemite. If the surfaces do not attach properly, you can't update the surface firmware. S
So, it may take a few attempts in order to successfully perform the firmware update. Please closely follow the instructions in the attached EuControl 3.2.2 Read Me or knowledge base article here, and you should be able to successfully update each of your surfaces. Once the firmware update is complete, surfaces should consistently attach in EuControl as expected.
Lastly, a long time request for Edit/Mix windows to follow surface bank selection is working in Pro Tools 12+. Various other fixes are listed below.
Important Installation Note for Artist Series and S3 Users
You must update the firmware on Artist Series and S3 control surfaces after installing EuControl Software 3.2.2. Instructions are available in attached 3.2.2 Read Me and knowledge base article here.
Surface firmware versions after updating firmware:
S3 1.1.3
Transport 1.1.8
Control 1.3.7
Mix 1.5.4
Color 1.1.10
What's New
- Support for Mac OS X 10.10 "Yosemite"
- A Soft Key Editor for S3 control surfaces (see the PDF Soft Key Editor for S3 for instructions on using the Soft Key Editor)
- For Pro Tools 12 and higher, the preference for Mix and/or Edit windows to follow surface bank selection is now working. In Pro Tools, go to Pro Tools > Preferences > Mixing to enable the functionality.
What's Fixed
- The following issues have been fixed since the previous release of EuControl software.
- (S3 Only) Random faders no longer become unresponsive (EUCON-3522)
- Option to auto-launch Studio Monitor Express is now removed from Mac System Preferences panel as Studio Monitor Express is no longer supported on Mac (EUCON-3518).
- S3 Channel Control EQ parameters now refresh correctly after auto-inserting a default EQ from the surface (EUCON-3505)
- S3 Channel Control EQ parameters now display correctly after hiding/showing certain tracks on the surface (EUCON-3305)
- S3 Channel Control Input parameters are now assigned to the proper encoders (EUCON-3461)
- S3 Channel Strip LEDs now light correctly when the Channel Encoders are in Channel mode (EUCON-3024)
- Improved EuControl icon in the Menu bar on Macs with Retina displays (EUCON-3381)
- When editing a plug-in from the surface, the corresponding plug-in window in Pro Tools is now shown (EUCON-3263)
- Pro Tools Solo mode no longer resets to Latch when EuControl is relaunched (EUCON-3257)
- When quitting EuControl, you are no longer asked to save soft key assignments if no changes were made to the soft key assignments (EUCON-2830)
OS Compatibility
- Windows 7 64-bit
- Windows 8.x 64-bit
- Mac OS 10.10.2+
- Mac OS 10.9.5
Artist Users, log into your Artist Account here to access EuControl 3.2.2.
Pro Tools | S3 users, log into your Avid account here to access EuControl 3.2.2.
Thanks for all your patience - I know it was a long wait. Marianna |
Posted by: tcurren@aol.com
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (1) |
No comments:
Post a Comment