Well I did find out when they added the additional Unity they actually added a sub panel or expanded the existing power box so that might be why this behavior has been consistently intermittent since I came back in December. Today the AC in the machine room was messed up and one of the Unitys went bonkers. Apparently the engineer logged in remotely and reset a switch and then power cycling all the chassis and it came back. I wasn't involved but by switch I assume that would be a fibre switch or there some other kind of switch in the media net Unity world that could be triggered by a thermal sensor of some sort. Is there a provision in Unity management software to examine thermal sensors and reset them? Just curious and want to expand my Unity knowledge which is very limited on the engineering side.
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (3) |
No comments:
Post a Comment