On Mar 6, 2013, at 8:55 AM, Dom Q. Silverio wrote:
> Uninstall the Keyspan drivers. Unplug the device from the USB port.
> Shutdown (if you have an xw8600, unplug the power cable for 2 minutes to
> discharge the PC completely). Reboot. Delete your MC State, Site Settings
> and Site Attribute files. Reinstall the drivers and reboot. Connect the
> device and start Avid.
>
Do the Hokey-Pokey and shake it all around . . .
>
> Dom Q. Silverio
>
> On Wed, Mar 6, 2013 at 11:36 AM, Lou Wirth loutv@mindspring.com> wrote:
>
> > Last night I had to actually digitize some tape. Have not done this in 3
> > years. I had to relearn the process all over again. Of course I figured I
> > needed updated keyspan drivers as my Avid did not see anything on direct
> > port. So I updated the driver and to my surprise, there it was and it
> > worked. I digitized several clips and left. Now in this morning to pick
> > up where I left off. But now, nothing I do lets Avid see anything on the
> > direct port. No keyspan. Is there something else I need to do to help
> > persuade my system that decks are attached via the keyspan?
> >
> > thanks
> >
> > Lou
> > Lou Wirth Productions
> > 500Tamal Plaza, Suite 522
> > Corte Madera, CA 94925
> > www.louwirth.com
> > 415-924-9411p
> >
> >
> >
[Non-text portions of this message have been removed]
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (3) |
No comments:
Post a Comment