Not being an engineer this kind of stuff always freaks me a little. But I was told it's easy. I picked up a very used PVM20M4U with SDI board and I want to pull the board and put in my PVM. Mine is very pristine and has far less use than the one I am pulling from which is why I don't want to just swap them out.
I am staring at the back of the monitor, see four phillips screws which I took out. But there are a series of plastic tabs securing the housing lip over the back. Do I pull these out and then the back slides down? Or should I give up and hire someone ;-)
thanks
Lou
Lou Wirth Productions
500Tamal Plaza, Suite 522
Corte Madera, CA 94925
www.louwirth.com
415-924-9411p
__._,_.___
Search the official Complete Avid-L archives at: http://archives.bengrosser.com/avid/
MARKETPLACE
.
__,_._,___
No comments:
Post a Comment