Following the specs given in your forum post DO NOT WORK. It's not that they couldn't figure it out, it's that the pinning is WRONG for this application. There is being frugal, and then there is being a cheap ass. Buy the freaking cable.
JDS
--- In Avid-L2@yahoogroups.com, "johnrobmoore" <bigfish@...> wrote:
>
> That's just what I was thinking. Those RS-422 patch panels that use two audio patch cords seem like they would reverse the tx and rx just by patching the criss cross instead of straight across. So you're saying that works? If so I'm hard pressed to see how the ABC folks couldn't make a cable to do the same. I know first hand many of those guys are top notch techs. All it would take is an ohm meter to verify the pins on the Avid cable. Greg I'll solder one up early next week and if it works you owe me an OKI dog. Of course I'm not sure what the protools control element might do. Do you have a 422 patch at Secret HQ that would allow for this patch bay trick?
>
> --- In Avid-L2@yahoogroups.com, "Frank Felker" <FJFelker@> wrote:
> >
> > The trick I used was to wire the cross connections between two ports on our
> > 422 patch panel. That way, one just had to patch an Avid through the crossed
> > patches to the remote controller in the machine room. Flexible and
> > fool-resistant.
> >
> > frank felker
> >
> > -----Original Message-----
> > From: Avid-L2@yahoogroups.com [mailto:Avid-L2@yahoogroups.com] On Behalf Of
> > jeffsengpiehl
> > Sent: Friday, September 09, 2011 9:40 PM
> > To: Avid-L2@yahoogroups.com
> > Subject: [Avid-L2] Re: Remote play
> >
> >
> > No the trick is to *BUY* the special serial control cable from Avid.
> > I had the folks at ABC who build cables for a living follow the spec's
> > listed in the forums and it does NOT work. Buy the cable from Avid, and be
> > done with it.
> >
> > JDS
> >
> > --- In Avid-L2@yahoogroups.com, Greg Huson <Greg@> wrote:
> > >
> > > So I guess the trick would be to build a special serial control patchbay
> > cable that did the crossover job - and keep that hidden in my desk! Maybe
> > next week...
> > >
> > > gh
> > > ----------------------------------------------------
> > > Greg Huson
> > > Secret Headquarters, Inc
> > > Post Production / Production
> > > Culver City, CA
> > > 323 677 2092
> > > www.DigitalServiceStation.com
> > > greg (at) SecretHQ.com
> > > facebook.com/greg.huson
> > > www.SecretHQ.com
> > >
> > >
> > >
> > > On Sep 9, 2011, at 3:14 PM, johnrobmoore wrote:
> > >
> > > > Here's an old thread on the cross over cable pin out etc....
> > > > http://community.avid.com/forums/p/9388/53107.aspx#53107
> > > >
> > > > --- In Avid-L2@yahoogroups.com, "Gajit" <jonathan@> wrote:
> > > > >
> > > > > Here is a link to the remote play info site.
> > http://avid.custkb.com/avid/app/selfservice/search.jsp?DocId=243637
> > > > >
> > > > > you can order the cables from avid...but if you have an engineer
> > handy, I believe it is a matter of simply switching a couple pins in the
> > cable. The cable is called a 422 cross-over cable or a machine control
> > cable.
> > > > >
> > > > > --- In Avid-L2@yahoogroups.com, Greg Huson <Greg@> wrote:
> > > > > >
> > > > > > Yes- video satellite. I should pay extra to link two bays
> > together... grrrrr....
> > > > > >
> > > > > > gh
> > > > > > ----------------------------------------------------
> > > > > > Greg Huson
> > > > > > Secret Headquarters, Inc
> > > > > > Post Production / Production
> > > > > > Culver City, CA
> > > > > > 323 677 2092
> > > > > > www.DigitalServiceStation.com
> > > > > > greg (at) SecretHQ.com
> > > > > > facebook.com/greg.huson
> > > > > > www.SecretHQ.com
> > > > > >
> > > > > >
> > > > > >
> > > > > > On Sep 8, 2011, at 3:55 PM, Terence Curren wrote:
> > > > > >
> > > > > > > There is also the video satellite approach with PT.
> > > > > > >
> > > > > > > --- In Avid-L2@yahoogroups.com, "bouke" <bouke@> wrote:
> > > > > > > >
> > > > > > > > Should work, at least it used to work...
> > > > > > > > But, you need the correct cabling.
> > > > > > > >
> > > > > > > > Bouke
> > > > > > > >
> > > > > > > > VideoToolShed
> > > > > > > > van Oldenbarneveltstraat 33
> > > > > > > > 6512 AS NIJMEGEN
> > > > > > > > The Netherlands
> > > > > > > > +31 24 3553311
> > > > > > > > www.videotoolshed.com
> > > > > > > > For large files:
> > > > > > > > http://dropbox.yousendit.com/BoukeVahl998172
> > > > > > > >
> > > > > > > > ----- Original Message -----
> > > > > > > > From: "Greg Huson" <Greg@>
> > > > > > > > To: <Avid-L2@yahoogroups.com>
> > > > > > > > Sent: Thursday, September 08, 2011 11:46 PM
> > > > > > > > Subject: Re: [Avid-L2] Re: Remote play
> > > > > > > >
> > > > > > > >
> > > > > > > > > Mac, and I was trying to drag my avid around using my protools
> > system's
> > > > > > > > > tape controls. I guess that's not going to work...
> > > > > > > > >
> > > > > > > > > gh
> > > > > > > > > ----------------------------------------------------
> > > > > > > > > Greg Huson
> > > > > > > > > Secret Headquarters, Inc
> > > > > > > > > Post Production / Production
> > > > > > > > > Culver City, CA
> > > > > > > > > 323 677 2092
> > > > > > > > > www.DigitalServiceStation.com
> > > > > > > > > greg (at) SecretHQ.com
> > > > > > > > > facebook.com/greg.huson
> > > > > > > > > www.SecretHQ.com
> > > > > > > > >
> > > > > > > > >
> > > > > > > > >
> > > > > > > > > On Sep 8, 2011, at 1:46 PM, jeffsengpiehl wrote:
> > > > > > > > >
> > > > > > > > >> you need the correctly wired serial cable, not a stock one,
> > and you need
> > > > > > > > >> to replace your microsoft serial driver.
> > > > > > > > >>
> > > > > > > > >> JDS
> > > > > > > > >>
> > > > > > > > >> --- In Avid-L2@yahoogroups.com, Greg Huson <Greg@> wrote:
> > > > > > > > >> >
> > > > > > > > >> > I'm trying to use remote play on a symphony 5.5.3, but the
> > option is
> > > > > > > > >> > grayed out. Anyone using this feature?
> > > > > > > > >> >
> > > > > > > > >> > gh
> > > > > > > > >> > ----------------------------------------------------
> > > > > > > > >> > Greg Huson
> > > > > > > > >> > Secret Headquarters, Inc
> > > > > > > > >> > Post Production / Production
> > > > > > > > >> > Culver City, CA
> > > > > > > > >> > 323 677 2092
> > > > > > > > >> > www.DigitalServiceStation.com
> > > > > > > > >> > greg (at) SecretHQ.com
> > > > > > > > >> > facebook.com/greg.huson
> > > > > > > > >> > www.SecretHQ.com
> > > > > > > > >> >
> > > > > > > > >> >
> > > > > > > > >> >
> > > > > > > > >> >
> > > > > > > > >> >
> > > > > > > > >> > [Non-text portions of this message have been removed]
> > > > > > > > >> >
> > > > > > > > >>
> > > > > > > > >>
> > > > > > > > >
> > > > > > > > >
> > > > > > > > >
> > > > > > > > > [Non-text portions of this message have been removed]
> > > > > > > > >
> > > > > > > > >
> > > > > > > > >
> > > > > > > > > ------------------------------------
> > > > > > > > >
> > > > > > > > > Search the offical complete Avid-L archives at:
> > > > > > > > > http://archives.bengrosser.com/avid/
> > > > > > > > >
> > > > > > > > > If you want to donate to Red Cross quake relief, you can do so
> > through
> > > > > > > > > your cell phone. Text redcross to 90999 to make a $10
> > donation. It will be
> > > > > > > > > on your next cell bill.Yahoo! Groups Links
> > > > > > > > >
> > > > > > > > >
> > > > > > > > >
> > > > > > > >
> > > > > > >
> > > > > > >
> > > > > >
> > > > > >
> > > > > >
> > > > > > [Non-text portions of this message have been removed]
> > > > > >
> > > > >
> > > >
> > > >
> > >
> > >
> > >
> > > [Non-text portions of this message have been removed]
> > >
> >
> >
> >
> >
> > ------------------------------------
> >
> > Search the offical complete Avid-L archives at:
> > http://archives.bengrosser.com/avid/
> >
> > If you want to donate to Red Cross quake relief, you can do so through your
> > cell phone. Text redcross to 90999 to make a $10 donation. It will be on
> > your next cell bill.Yahoo! Groups Links
> >
>
If you want to donate to Red Cross quake relief, you can do so through your cell phone. Text redcross to 90999 to make a $10 donation. It will be on your next cell bill.
No comments:
Post a Comment