Need advice please - I haven't done this in years, so I must admit to be a bit rusty. We have a 2 cam shoot, producer wants to 'switch live' between the 2 cams. So I created a group clip - to do this I used mark-in points (I also had outs marked) and created a group clip from the BIN menu pull down. (NOTE - one source was a subclip that I created from of an ingested tape, the other source was media xfered from a xd-cam that came in as QT files) When I loaded this new Grp clip into the source monitor I noticed that the inpoint was way earlier than what I had marked. So I tried with no out points marked - got the same results.
Then I tried a MultiGroup, but again, the actual in is WAY earlier than what I had marked.
Interestingly - when I reach the point on the Group Clip that I wanted to switch between, the 2 cams are in perfect sync.
Am I missing a step here ? - i don't remember having had these problems when I did this years ago.
Any thoughts ?? (running PC based HD Media Comoser, vers 3.5.9)
thanks in advance
DB
If you want to donate to Red Cross quake relief, you can do so through your cell phone. Text redcross to 90999 to make a $10 donation. It will be on your next cell bill.
No comments:
Post a Comment