also, if this is a new install, if you work in PAL (not sure where you are from), there is a registry entry to change the system from NTSC to PAL....
From: jay jones <jayjones433@yahoo.co.uk>
To: "Avid-L2@yahoogroups.com" <Avid-L2@yahoogroups.com>
Sent: Tuesday, December 10, 2013 12:59 PM
Subject: Re: [Avid-L2] Capture Manager cues but not recording
To: "Avid-L2@yahoogroups.com" <Avid-L2@yahoogroups.com>
Sent: Tuesday, December 10, 2013 12:59 PM
Subject: Re: [Avid-L2] Capture Manager cues but not recording
hi Stu,
i'll take a look, thanks very much for your suggestions
thanks again
On Tuesday, 10 December 2013, 15:46, Stu Mac <stumac1963@yahoo.com> wrote:
Ok, usually though it means that CM is out of sync in some way with device its trying to control, unless there is some unknown incompatibility with the server. As long as all the services are running, and you may want to check under the messages tab, in case there might be a clue there....good luck!
From: jay jones <jayjones433@yahoo.co.uk>
To: "Avid-L2@yahoogroups.com" <Avid-L2@yahoogroups.com>
Sent: Monday, December 9, 2013 4:05 PM
Subject: Re: [Avid-L2] Capture Manager cues but not recording
To: "Avid-L2@yahoogroups.com" <Avid-L2@yahoogroups.com>
Sent: Monday, December 9, 2013 4:05 PM
Subject: Re: [Avid-L2] Capture Manager cues but not recording
hi stu
cheers for your response, this CM is the 2nd one of two the 1st one has the TC card
many thanks again
On Monday, 9 December 2013, 18:46, Stu Mac <stumac1963@yahoo.com> wrote:
Did you have an Adrienne timecode card in the SR2500? CM needs to sync to timecode, so it's probably looking for that...just a guess though.
From: jay jones <jayjones433@yahoo.co.uk>
To: "Avid-L2@yahoogroups.com" <Avid-L2@yahoogroups.com>
Sent: Sunday, December 8, 2013 1:13 PM
Subject: [Avid-L2] Capture Manager cues but not recording
To: "Avid-L2@yahoogroups.com" <Avid-L2@yahoogroups.com>
Sent: Sunday, December 8, 2013 1:13 PM
Subject: [Avid-L2] Capture Manager cues but not recording
Hi All
I haven't been here for a while, I'm hoping someone could help with a capture manager issue, original CM on intel SR2500 is no more, rebuilt on DL360 which looks ok but when starting an instant record, the GUI just sits there cueing.
Unsure of where the issue lies, re-installed SQL 2005 with mediabrowse DB etc, all looks the same as the other CM but will not record.
Any help would be greatly appreciated. Many thanks in advance.
__._,_.___
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (6) |
.
__,_._,___
No comments:
Post a Comment